Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO EXTENDED, 5.3 T, 4L60E/M30REPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALBODY ELECTRICALOEM CONNECTOR END VIEWSCRUISE CONTROL CONNECTOR END VIEWSCRUISE CONTROL MODULE (CCM) CONNECTOR END VIEW
2006 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.3 T, 4L60E/M30
Cruise Control Module (CCM) Connector End View
2006 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.3 T, 4L60E/M30SECTION Cruise Control Module (CCM) Connector End View
Cruise Control Module (CCM) (Gas K34 w/o JL4)
| Connector Part Information |
|
||
|---|---|---|---|
| Pin | Wire Color | Circuit No. | Function |
| A | GY | 397 | Cruise Control On Switch Signal |
| B | D-BU | 84 | Cruise Control Set/Coast Switch Signal |
| C | GY/BK | 87 | Cruise Control Resume/Accel Switch Signal |
| D | PU | 420 | TCC Brake Switch/Cruise Control Release Signal |
| E | BK | 350 | Ground |
| F | PK | 439 | Ignition 1 Voltage |
| G | WH | 17 | Stop Lamp Switch Signal - w/Cutaway |
| L-BU | 1320 | CHMSL Supply Voltage/Stop Lamp Supply Voltage - w/o Cutaway | |
| H | D-GN | 83 | Cruise Control Inhibit Signal |
| J | L-BU/BK | 396 | Cruise Control Engaged Signal |
| K | D-GN/WH | 817 | Vehicle Speed Signal |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.