SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CHEVY EXPRESS G2500, VAN CARGO EXTENDED, 5.3 T, 4L60E/M30REPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEEXTERIOR BODY PANELSBODY FRONT ENDREPAIR INSTRUCTIONSHOOD LATCH RELEASE CABLE REPLACEMENTREMOVAL PROCEDURE
2006 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.3 T, 4L60E/M30

Removal Procedure

2006 Chevrolet Chevy Express G2500, Van Cargo Extended, 5.3 T, 4L60E/M30SECTION Removal Procedure
  1. Raise and support the hood.
    2. Fig 1: Removing Cable From Hood Latch
    GM314944Courtesy of GENERAL MOTORS CORP.
  2. Remove the cable (1) from the hood latch (3).
    3. Fig 2: Removing Cable From Retainer On Radiator Support
    GM314949Courtesy of GENERAL MOTORS CORP.
  3. Remove the cable (1) from the retainer on the radiator support.
  4. Push the cable (1) and the grommet into the cab from the engine compartment.
  5. Remove the left side hinge pillar trim panel from the body. Refer to Trim Replacement - Hinge Pillar in Interior Trim.
  6. Remove the screws retaining the cable handle (3) to the body.
  7. Remove the handle (3) from the body.
  8. Remove the cable (1) from the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.