Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CAB & CHASSIS SILVERADO 2D PICKUP, 8.1 G, 4WD, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)QUICK LOOKUPSWIRING DIAGRAMSOEM CONNECTOR END VIEWSPOWERTRAIN CONTROL MODULE (PCM) CONNECTOR END VIEWS (4.8L, 5.3L, 6.0L)POWERTRAIN CONTROL MODULE CONNECTOR END VIEW (PCM) C2
2006 Chevrolet Cab & Chassis Silverado 2D Pickup, 8.1 G, 4WD, Automatic
Powertrain Control Module Connector End View (PCM) C2
2006 Chevrolet Cab & Chassis Silverado 2D Pickup, 8.1 G, 4WD, AutomaticSECTION Powertrain Control Module Connector End View (PCM) C2
Powertrain Control Module (PCM) Connector End Views
Connector Part Information
|
Powertrain Control Module (PCM) C2
| Pin | Wire Color | Circuit No. | Function |
|---|---|---|---|
| 1 | BK/WH | 451 | Ground |
| 2 | BN | 418 | TCC PWM Solenoid Valve Control (A/T) |
| 3 | TN | 1465 | Fuel Pump Relay Control - Secondary (Except L59/HP2) |
| 4 | - | - | Not Used |
| 5 | TN/BK | 464 | Delivered Torque Signal (NW7) |
| 6 | RD/BK | 1228 | PC Solenoid Valve High Control (A/T) |
| 7 | - | - | Not Used |
| 8 | L-BU/WH | 1229 | PC Solenoid Valve Low Control (A/T) |
| 9 | D-GN/ WH |
465 | Fuel Pump Relay Control |
| 10 | WH | 121 | Engine Speed Signal (Except HP2) |
| L-BU/BK | 647 | Medium Resolution Engine Speed Signal (HP2) | |
| 11-13 | - | - | Not Used |
| 14 | RD/BK | 380 | A/C Refrigerant Pressure Sensor Signal (A/C) |
| 15 | BN | 25 | Charge Indicator Control (20/30 Series) |
| PU | 5428 | Generator Regulator Control (10 Series except HP2) | |
| 16 | GY/BK | 1694 | 4WD Low Signal (NP8 or NP1) |
| 17 | - | - | Not Used |
| 18 | D-GN | 1433 | Clutch Start Switch Signal (M/T) |
| 19 | BK/WH | 1695 | Axle Switch Signal (4WD) |
| 20 | L-GN/BK | 822 | VSS Low Signal |
| 21 | PU/WH | 821 | VSS High Signal |
| 22 | RD/BK | 1230 | AT ISS High Signal (MT1) |
| 23 | D-BU/WH | 1231 | AT ISS Low Signal (MT1) |
| 24 | - | - | Not Used |
| 25 | TN | 472 | IAT Sensor Signal |
| 26 | PU | 2121 | IC 1 Control |
| 27 | RD | 2127 | IC 7 Control |
| 28 | L-BU/WH | 2126 | IC 6 Control |
| 29 | D-GN/ WH |
2124 | IC 4 Control |
| 30 | - | - | Not Used |
| 31 | YE | 492 | MAF Sensor Signal |
| 32 | L-GN | 432 | MAP Sensor Signal |
| 33 | D-BU | 473 | High Speed Cooling Fan Relay Control (10 Series) |
| 34 | D-GN/ WH |
428 | EVAP Canister Purge Solenoid Control |
| 35 | WH | 121 | Engine Speed Signal (HP2) |
| 35-38 | - | - | Not Used |
| 39 | RD | 631 | 12-Volt Reference |
| 40 | BK/WH | 451 | Ground |
| 41 | - | - | Not Used |
| 42 | TN/BK | 422 | TCC Solenoid Valve Control (M30/M32/M33) |
| 43 | D-GN/ WH |
459 | A/C Compressor Clutch Relay Control (A/C) |
| 44 | - | - | Not Used |
| 45 | WH | 1310 | EVAP Canister Vent Solenoid Control |
| 46 | BN/WH | 419 | MIL Control |
| 47 | YE/BK | 1223 | 2-3 Shift Solenoid Valve Control (A/T) |
| 48 | L-GN | 1222 | 1-2 Shift Solenoid Valve Control (A/T) |
| 49 | YE/BK | 1827 | Vehicle Speed Signal |
| 50 | D-GN/ WH |
817 | Vehicle Speed Signal |
| 51 | YE/BK | 1227 | TFT Sensor Signal (A/T) |
| 52 | BN | 2391 | HO2S Heater Low Control Bank 1 Sensor 2 |
| 53 | RD/WH | 3223 | HO2S Heater Low Control Bank 2 Sensor 2 |
| 54 | PU/WH | 1589 | Fuel Level Sensor Signal - Primary |
| 55-56 | - | - | Not Used |
| 57 | BK | 552 | Low Reference |
| 58 | TN/WH | 332 | Oil Pressure Sensor Signal |
| 59 | PU | 806 | Crank Voltage |
| 60 | BN | 2129 | Low Reference |
| 61 | BN/WH | 2130 | Low Reference |
| 62 | GY | 773 | Transmission Range Switch Signal C (A/T) |
| 63 | PK | 1224 | Transmission Fluid Pressure Switch Signal A (A/T) |
| 64 | D-GN | 890 | Fuel Tank Pressure Sensor Signal |
| 65 | - | - | Not Used |
| 66 | PU/WH | 2128 | IC 8 Control |
| 67 | RD/WH | 2122 | IC 2 Control |
| 68 | D-GN | 2125 | IC 5 Control |
| 69 | L-BU | 2123 | IC 3 Control |
| 70 | TN/WH | 2500 | High Speed GMLAN Serial Data (+) (HP2) |
| 71 | TN | 2501 | High Speed GMLAN Serial Data (-) (HP2) |
| 72 | BK/WH | 3113 | HO2S Heater Low Control Bank 1 Sensor 1 |
| 73 | D-BU | 1936 | Fuel Level Sensor Signal - Secondary |
| 74 | L-GN | 3212 | HO2S Heater Low Control Bank 2 Sensor 1 |
| 75 | GY | 23 | Generator Field Duty Cycle Signal (Except HP2) |
| 76-79 | - | - | Not Used |
| 80 | BK | 2751 | Low Reference (A/C) |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.