Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CAB & CHASSIS SILVERADO 2D PICKUP, 8.1 G, 4WD, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ELECTRICALCHARGING SYSTEMSBATTERY, CHARGING SYSTEM AND STARTING SYSTEM - INTRODUCTIONREPAIR INSTRUCTIONSGENERATOR BATTERY CONTROL MODULE REPLACEMENTREMOVAL PROCEDURE
2006 Chevrolet Cab & Chassis Silverado 2D Pickup, 8.1 G, 4WD, Automatic
Removal Procedure
2006 Chevrolet Cab & Chassis Silverado 2D Pickup, 8.1 G, 4WD, AutomaticSECTION Removal Procedure
- Disconnect the engine harness electrical connector from the generator battery control module.
- Remove the negative battery cable. Refer to Battery Negative Cable Replacement (4.3L Engine) .
- Cut the tie straps and electrical tape attaching the generator battery control module to the battery cable.
- Squeeze the negative battery cable branches together.
- Slide the generator battery control module off of the negative battery cable.
IMPORTANT:
Note the orientation of the generator battery control module prior to removal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.