Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CAB & CHASSIS SILVERADO 2D PICKUP, 8.1 G, 4WD, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMESEATSSEAT SYSTEMREPAIR INSTRUCTIONSMEMORY SEAT CONTROL MODULE REPLACEMENTINSTALLATION PROCEDURE
2006 Chevrolet Cab & Chassis Silverado 2D Pickup, 8.1 G, 4WD, Automatic
Installation Procedure
2006 Chevrolet Cab & Chassis Silverado 2D Pickup, 8.1 G, 4WD, AutomaticSECTION Installation Procedure
- Position the module into the vehicle.
- Connect the lower electrical harness connectors (2).
- Slide the module (2) to the left to engage the lower retainers.
- Install the module retaining screws (3).
Tighten: Tighten the screws to 3 N.m (26 lb in).
- Connect the upper electrical harness connectors (3).
- Install the seat cushion. Refer to Seat Cushion Frame Replacement - Front .
- If a new memory seat module was installed, calibrate the seat. Refer to Memory Seat Calibration Procedure .
NOTE:
Refer to Fastener Notice
in Cautions and Notices.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.