Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2006CAB & CHASSIS SILVERADO 2D PICKUP, 8.1 G, 4WD, AUTOMATICREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCOMMUNICATION DEVICESPROGRAMMING AND SETUP - ALL SYSTEMSREPAIR INSTRUCTIONSENGINE CONTROL MODULE PROGRAMMING AND SETUPECM REPLACEMENT
2006 Chevrolet Cab & Chassis Silverado 2D Pickup, 8.1 G, 4WD, Automatic
ECM Replacement
2006 Chevrolet Cab & Chassis Silverado 2D Pickup, 8.1 G, 4WD, AutomaticSECTION ECM Replacement
If the engine control module (ECM) is replaced, the following procedures must be performed:
- The ECM Reprogramming-Refer to Service Programming System (SPS) .
- The Turbocharger Learn Procedure-Refer to Turbocharger Learn Procedure .
- Theft Deterrent-Refer to Programming Theft Deterrent System Components .
- The Fuel Injector Flow Rate Programming-Refer to Fuel Injector Flow Rate Programming .
- Engine Oil Life Remaining-When available, use a scan tool to reset the Engine Oil Life Remaining back to the original percentage recorded before the module was reprogrammed.
- Transmission Fluid Life Remaining-When available, use a scan tool to reset the Transmission Fluid Life Remaining back to the original percentage recorded before the module was reprogrammed.
- Fuel Filter Life Remaining-When available, use a scan tool to reset the Fuel Filter Life Remaining back to the original percentage recorded before the module was reprogrammed.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.