Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2005TAHOE 2WD V8-4.8L VIN VREPAIR AND DIAGNOSISBODY AND FRAMEBUMPERREAR BUMPERSERVICE AND REPAIR
2005 Chevrolet Tahoe 2WD V8-4.8L VIN V
Rear Bumper: Service and Repair
2005 Chevrolet Tahoe 2WD V8-4.8L VIN VSECTION Service and Repair
Bumper Replacement - Rear
Removal Procedure
1. Disconnect the license plate lamp harness.
2. Remove the impact bar nut (1).
3. Remove the plate nuts (2).
4. Remove the lower frame rail to bracket bolt (3).
5. Remove the side frame rail to bracket bolt (4).
6. Remove the rear trailer hitch to bumper bolts (1), if equipped.
7. Remove the rear bumper from the vehicle.
Installation Procedure
1. Position the rear bumper onto the vehicle.
2. Install the rear trailer hitch to bumper bolts (1), if equipped.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the impact bar nut (1).
Tighten the impact bar nut (1) to 50 N.m (37 lb ft).
4. Install the plate nuts (2).
Tighten the plate nuts (2) to 90 N.m (66 lb ft).
5. Install the lower frame rail to bracket bolt (3).
Tighten the lower frame rail to bracket bolt (3) to 100 N.m (74 lb ft).
6. Install the side frame rail to bracket bolt (4).
Tighten the side frame rail to bracket bolt (4) to 40 N.m (30 lb ft).
7. Install the bumper step pad.
8. Install the license plate lamp harness.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.