SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2005OPTRA5 BASE, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTHEADLIGHTSLIGHTING SYSTEMSDIAGNOSTIC INFORMATION AND PROCEDURESREAR COMPARTMENT LAMP(S) INOPERATIVETEST DESCRIPTION
2005 Chevrolet Optra5 Base, Standard

Test Description

2005 Chevrolet Optra5 Base, StandardSECTION Test Description

The numbers below refer to the step numbers on the diagnostic table.

  1. 1:  Bulb test. Clip one end of a jumper wire to the negative battery terminal. Clip the other end of the jumper wire onto one end of the bulb. Take the free end of the bulb, the end without the jumper attached, and touch it to the positive battery terminal.
Step Action Values Yes No
1 
  1. Remove the luggage compartment lamp bulb and inspect the filament.
  2. If the filament is not broken, test the bulb using the vehicle battery and a jumper wire.
Does the bulb pass the visual and physical inspection?		 - Go to Step 3  Go to Step 2 
2 Replace the bulb.
Did you complete the replacement?		 - System OK -
3
  1. Reinstall the luggage compartment lamp bulb.
  2. Inspect fuse Ef19.
Is fuse Ef19 open?		 - Go to Step 4  Go to Step 5 
4
  1. Inspect for a short circuit and repair it, if necessary.
  2. Replace the fuse.
Did you find and correct the condition?		 - System OK -
5 Inspect fuse Ef19.
Does the voltage at fuse Ef19 measure within the specified range?		 11-14 V Go to Step 7  Go to Step 6 
6 Repair the open power supply circuit for fuse Ef19.
Did you complete the repair?		 - System OK -
7
  1. Disconnect the luggage compartment lamp electrical connector.
  2. Measure the voltage at the orange wire.
Does the voltage at the OG wire measure within the specified range?		 11-14 V Go to Step 8  Go to Step 9 
8 Repair the open circuit between fuse Ef19 and the luggage compartment lamp.
Did you complete the repair?		 - System OK -
9
  1. Reconnect the luggage compartment lamp.
  2. Remove the luggage compartment lamp switch.
  3. With a voltmeter, or test lamp, test the PK/BK wire at the luggage compartment lamp switch.
Does the voltage at the luggage compartment lamp switch measure within the specified range?		 11-14 V Go to Step 11  Go to Step 10 
10 Repair the open circuit between the luggage compartment lamp and the luggage compartment lamp switch.
Did you complete the repair?		 - System OK -
11 Use an ohmmeter to measure the resistance between ground and the BK wire at the luggage compartment lamp switch connector, harness side.
Is the resistance equal to the specified value?		 0 Ω Go to Step 12  Go to Step 13 
12 Replace the luggage compartment lamp switch.
Did you complete the replacement?		 - System OK -
13 Repair the ground circuit for the interior courtesy lamp.
Did you complete the repair?		 - System OK -
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.