Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
2005 Chevrolet Malibu LSSECTION Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Turn the ignition OFF.
- Disconnect the electronic ignition (EI) module harness connector.
- Remove the ignition coil housing attachment bolts and remove the ignition coil housing.
- Remove the spark plugs using a 5/8 inch spark plug socket.
IMPORTANT:
Make sure that the water and debris are blown out of the spark plug holes before removing the spark plugs.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.