Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Removal Procedure
2005 Chevrolet Malibu LSSECTION Removal Procedure
- Relieve the fuel system pressure. Refer to Fuel Pressure Relief Procedure .
- Remove the pipe retaining clip from the fuel feed pipe (1).
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Disconnect the fuel feed pipe from the engine fuel rail. Refer to Quick Connect Fitting(s) Service (Metal Collar) .
- Cap or plug the fuel pipe and the engine fuel rail to prevent contamination.
- Remove the rear brake pipe bracket retaining nuts and release the brackets from the body studs.
- Release the pipe retainers (1) from the vehicle underbody.
- Remove the fuel feed pipe from the pipe retainers.
- Lower the rear of the pipe while moving the pipe rearward slightly, then lower the front of the pipe.
- Remove the fuel feed pipe from the vehicle.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.