Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2005MALIBU LSREPAIR AND DIAGNOSISBODY & FRAMESEATSSEAT SYSTEMREPAIR INSTRUCTIONSSEAT ADJUSTER MOTOR REPLACEMENT - FRONT (TILT)REMOVAL PROCEDURE

2005 Chevrolet Malibu LS

Removal Procedure

2005 Chevrolet Malibu LSSECTION Removal Procedure

CAUTION: Refer to SIR Caution .

Place the seat in the full up position to relieve tension on the motor.
Remove the front seat. Refer to Seat Replacement - Front Bucket .

Fig 1: Disconnecting Electrical Connectors

GM1331068

Courtesy of GENERAL MOTORS CORP.

Disconnect the electrical connectors.

Fig 2: Removing Seat Motor Fastener

GM1331073

Courtesy of GENERAL MOTORS CORP.

Remove the seat motor fastener.

Fig 3: Removing Seat Motor Roll Pin

GM1331074

Courtesy of GENERAL MOTORS CORP.

Remove the seat motor roll pin.

Fig 4: Removing Seat Motor

GM1331078

Courtesy of GENERAL MOTORS CORP.

Remove the seat motor.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.