SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2005IMPALA BASE, 3.8 KREPAIR AND DIAGNOSISELECTRICALINSTRUMENT PANEL SYSTEM DISPLAYS, GAUGES AND CONSOLEREPAIR INSTRUCTIONSMULTIFUNCTION ALARM MODULE REPLACEMENTINSTALLATION PROCEDURE
2005 Chevrolet Impala Base, 3.8 K

Installation Procedure

2005 Chevrolet Impala Base, 3.8 KSECTION Installation Procedure
    Fig 1: Radio Delete Plate & Screws
    GM697548Courtesy of GENERAL MOTORS CORP.
  1. Install the multifunction alarm module to the instrument panel by pressing in place until fully seated.
  2. Connect the electrical connector to the multifunction alarm module.
    3. Fig 2: Multifunction Alarm Module & Electrical Connector
    GM697546Courtesy of GENERAL MOTORS CORP.
  3. Install the radio delete plate to the instrument panel.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the screws to the radio delete plate.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

  5. Install the instrument cluster trim panel. Refer to Trim Plate Bezel Replacement - Instrument Panel (I/P) Cluster (Impala)  or Trim Plate Bezel Replacement - Instrument Panel (I/P) Cluster (Monte Carlo) .
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.