Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2005IMPALA BASE, 3.8 KREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTCRUISE CONTROL SYSTEMSREPAIR INSTRUCTIONSCRUISE CONTROL MODULE REPLACEMENTREMOVAL PROCEDURE

2005 Chevrolet Impala Base, 3.8 K

Removal Procedure

2005 Chevrolet Impala Base, 3.8 KSECTION Removal Procedure

The cruise control module is mounted to the left strut tower and must be serviced as a complete unit.

Fig 1: Removing/Installing Cruise Control Module & Cable

Courtesy of GENERAL MOTORS CORP.

Remove the cruise control cable from the cruise control module. Refer to Cruise Control Cable Replacement (3.4L) or Cruise Control Cable Replacement (3.8L) .
Disconnect the cruise control module electrical connector.

Fig 2: Removing/Installing Cruise Control Module & Shock Tower Nuts

Courtesy of GENERAL MOTORS CORP.

Remove the cruise control module shock tower nuts.
Remove the cruise control module.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.