Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2005CHEVY EXPRESS H1500, VAN PASSENGERREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 1 (ENGINE CONTROL SYSTEM - 4.3L - INTRODUCTION)REPAIR INSTRUCTIONSIGNITION COIL(S) REPLACEMENTREMOVAL PROCEDURE
2005 Chevrolet Chevy Express H1500, Van Passenger
Removal Procedure
2005 Chevrolet Chevy Express H1500, Van PassengerSECTION Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Remove the engine cover. Refer to Engine Cover Replacement in Interior Trim.
- Disconnect the ignition coil electrical connectors.
- Remove the ignition coil wire to the distributor.
- Remove the accelerator cable bracket.
- Remove the studs holding the bracket and the ignition coil to the intake manifold.
- Remove the bracket and the ignition coil.
- Drill and punch out the two rivets holding the ignition coil to the bracket.
- Remove the ignition coil from the bracket.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.