Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DBβ LIVE
HOMESERVICE MANUALSCHEVROLET2005CHEVY EXPRESS G3500, VAN PASSENGER, LQ4REPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 1 (ENGINE CONTROL SYSTEM - 4.3L - INTRODUCTION)REPAIR INSTRUCTIONSACCELERATOR CONTROLS CABLE REPLACEMENTREMOVAL PROCEDURE
2005 Chevrolet Chevy Express G3500, Van Passenger, LQ4
Removal Procedure
2005 Chevrolet Chevy Express G3500, Van Passenger, LQ4SECTION Removal Procedure
WARNING: This page is about a different variant/trim than selected.
- Remove the engine cover. Refer to Engine Cover Replacement in Interior Trim.
- Remove the air cleaner outlet resonator. Refer to Air Cleaner Outlet Resonator ReplacementΒ .
- Remove the accelerator cable from the throttle lever.
- Remove the accelerator cable from the engine cable bracket.
- Remove the accelerator cable from the accelerator pedal (2).
- Remove the accelerator cable from the bulkhead (1).
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.