Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2005CHEVY EXPRESS G3500, VAN PASSENGER, LQ4REPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTHEADLIGHTSLIGHTING SYSTEMSREPAIR INSTRUCTIONSPARK/TURN SIGNAL LAMP REPLACEMENT (BASE VEHICLES)INSTALLATION PROCEDURE
2005 Chevrolet Chevy Express G3500, Van Passenger, LQ4
Installation Procedure
2005 Chevrolet Chevy Express G3500, Van Passenger, LQ4SECTION Installation Procedure
- Install the bulb (1) into the socket by turning the bulb sockets in a clockwise direction.
- Connect the bulb socket (1) into the park/turn signal lamp.
- Install the park/turn signal lamp (2) to the grille (5).
- Install the park/turn signal lamp retaining screws (3) to the grille.
Tighten: Tighten the screws to 1.5 N.m (13 lb in).
NOTE:
Refer to Fastener Notice in Cautions and Notices.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.