Removal Procedure

2005 Chevrolet Chevy Express G3500, Van Passenger, LQ4SECTION Removal Procedure
  1. Remove the side door stepwell mat. Refer to Mat Replacement - Stepwell in Interior Trim.
  2. Remove the sliding side door check assembly. Refer to Sliding Door Check ReplacementΒ .
  3. Remove the sliding side door upper roller bracket cover. Refer to Roller Bracket Cover Replace - Sliding Door UpperΒ .
  4. Fig 1: Sliding Side Door Lower Roller Bolts
    GM334048Courtesy of GENERAL MOTORS CORP.
  5. Remove the bolts that retain the sliding side door lower roller bracket to the door.
  6. Remove the sliding side door lower roller bracket from the track.
  7. Remove the sliding side door lower roller bracket from the vehicle.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.