Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2005CAVALIER L4-2.2L VIN FREPAIR AND DIAGNOSISSTARTING AND CHARGINGPOWER AND GROUND DISTRIBUTIONFUSE BLOCKSERVICE AND REPAIR
2005 Chevrolet Cavalier L4-2.2L VIN F
Fuse Block: Service and Repair
2005 Chevrolet Cavalier L4-2.2L VIN FSECTION Service and Repair
UNDERHOOD ELECTRICAL CENTER OR JUNCTION BLOCK REPLACEMENT
REMOVAL PROCEDURE
1. Open the hood.
2. Disconnect the negative battery cable from the battery.
3. Remove the air cleaner mounting bracket.
4. Remove the push-in retainer (3) from the electrical center.
5. Remove the electrical center from the inner fender.
6. Turn the electrical center over and remove the bottom cover.
7. Remove the four plastic wire retainers.
8. Label and remove the wires.
NOTE: Note the correct routing of the electrical wiring. Failure to reinstall the wiring properly could result in damage to the wiring.
9. Turn the electrical center right side up and remove the fuses and relays.
10. Remove the electrical center from the vehicle.
INSTALLATION PROCEDURE
1. Position the electrical center in the vehicle.
2. Install the fuses and relays.
3. Turn the electrical center over and install the wires.
4. Install the four plastic wire retainers.
5. Install the bottom cover to the electrical center.
6. Install the electrical center to the inner fender.
7. Install the push-in retainer (3) to the electrical center.
8. Install the air cleaner mounting bracket.
9. Connect the negative battery cable to the battery.
10. Close the hood.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.