Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2005CAVALIER L4-2.2L VIN FREPAIR AND DIAGNOSISSPECIFICATIONSMECHANICAL SPECIFICATIONSEXHAUST SYSTEMEXHAUST MANIFOLD
2005 Chevrolet Cavalier L4-2.2L VIN F
Exhaust Manifold
2005 Chevrolet Cavalier L4-2.2L VIN FSECTION Exhaust Manifold
Exhaust Manifold to Cylinder Head Nut 12 Nm (9 ft. lbs.)
Exhaust Manifold to Cylinder Head Stud 10 Nm (89 inch lbs.)
Exhaust Manifold Pipe Flange Stud 16 Nm (12 ft. lbs.)
Heat Shield to Exhaust Manifold Bolt 10 Nm (89 inch lbs.)
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.