Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2005CAVALIER L4-2.2L VIN FREPAIR AND DIAGNOSISPOWERTRAIN MANAGEMENTCOMPUTERS AND CONTROL SYSTEMSMANIFOLD PRESSURE/VACUUM SENSORSERVICE AND REPAIR
2005 Chevrolet Cavalier L4-2.2L VIN F
Manifold Pressure/Vacuum Sensor: Service and Repair
2005 Chevrolet Cavalier L4-2.2L VIN FSECTION Service and Repair
MANIFOLD ABSOLUTE PRESSURE (MAP) SENSOR REPLACEMENT
REMOVAL PROCEDURE
1. Remove the air cleaner outlet resonator.
2. Remove the accelerator cable bracket.
3. Disconnect the manifold absolute pressure (MAP) sensor harness connector.
4. Remove the MAP sensor (2) from the intake manifold.
5. Inspect the seal for damage.
IMPORTANT: If the MAP sensor seal is damaged, the MAP sensor must be replaced.
INSTALLATION PROCEDURE
1. Install the MAP sensor (2) into the intake manifold.
IMPORTANT: Use the new MAP sensor seal provided with the new MAP sensor.
2. Connect the MAP sensor harness connector.
3. Install the accelerator cable bracket.
4. Install the air cleaner outlet resonator.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.