Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2005CAVALIER L4-2.2L VIN FREPAIR AND DIAGNOSISBODY AND FRAMETESTING AND INSPECTIONCOMPONENT TESTS AND GENERAL DIAGNOSTICSALIGNMENT CHECKING
2005 Chevrolet Cavalier L4-2.2L VIN F
Alignment Checking
2005 Chevrolet Cavalier L4-2.2L VIN FSECTION Alignment Checking
Alignment Checking
Use a measuring tram gauge as an accurate method of determining the alignment of the underbody. The tram gauge set required to perform the recommended measuring checks must include a vertical pointer capable of reaching 457 mm (18 in).
The following two types of measurement may be made using a tram gauge:
* Direct point to point measurements
* Measurements calculated on a horizontal plane (datum line) parallel to the underbody
Equally set the vertical pointers. Take the point to point measurements on the following components:
* The Steering Components
* The Suspension Components
* The Engine Compartment Components
Dimensions that are measured to gauge holes are measured to the center of the holes and flush to the adjacent surface metal unless otherwise specified. It is recommended that the diagonal dimensions be cross body checked on both sides in order to verify the dimensional accuracy of the vehicle underbody.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.