Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2005BLAZER 2WD V6-4.3L VIN XREPAIR AND DIAGNOSISBODY AND FRAMELOCKSKEYLESS ENTRYKEYLESS ENTRY RECEIVERSERVICE AND REPAIR
2005 Chevrolet Blazer 2WD V6-4.3L VIN X
Keyless Entry Receiver: Service and Repair
2005 Chevrolet Blazer 2WD V6-4.3L VIN XSECTION Service and Repair
REMOTE CONTROL DOOR LOCK RECEIVER REPLACEMENT
REMOVAL PROCEDURE
1. Remove the left side instrument panel sound insulator.
2. Disconnect the electrical connector.
3. Remove the remote control door lock receiver from the instrument panel sound insulator by unsnapping it.
INSTALLATION PROCEDURE
1. Install the remote control door lock receiver from the instrument panel sound insulator by snapping it.
2. Connect the electrical connector.
3. Install the left side instrument panel sound insulator.
4. Reprogram the transmitters. Refer to Transmitter Programming. Programming and Relearning
5. Test the operation of the system.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.