SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2005AVEO LS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSISENGINE MECHANICALSTARTERBATTERY, CHARGING SYSTEM AND STARTING SYSTEMREPAIR INSTRUCTIONSBATTERY NEGATIVE CABLE DISCONNECT/CONNECT PROCEDUREREMOVAL PROCEDURE
2005 Chevrolet Aveo LS, 4D Sedan, Standard

Removal Procedure

2005 Chevrolet Aveo LS, 4D Sedan, StandardSECTION Removal Procedure
    CAUTION: Before servicing any electrical component, the ignition key must be in the OFF or LOCK position and all electrical loads must be OFF, unless instructed otherwise in these procedures. If a tool or equipment could easily come in contact with a live exposed electrical terminal, also disconnect the negative battery cable. Failure to follow these precautions may cause personal injury and/or damage to the vehicle or its components.
  1. Record all preset and theft codes, (if equipped), from the radio.
  2. Turn the ignition switch to the OFF position.
  3. Verify that all the electrical components are OFF such as interior lights, all doors are closed, the underhood lamp, etc.
  4. Loosen the clamping bolt from the battery negative cable.
  5. Remove the battery negative cable from the battery.
  6. Position the battery negative cable away from any body ground.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.