Sending Units & Sensors

2005 Chevrolet Aveo LS, 4D Sedan, StandardSECTION Sending Units & Sensors
SENDING UNITS & SENSORS LOCATION

Component Location
A/C Refrigerant Pressure Sensor On high pressure refrigerant line. See Figure.
Camshaft Position (CMP) Sensor Top front of engine, near the camshaft gear. See Figure.
Crankshaft Position (CKP) Sensor On left front of engine, below the oil filter. See Figure.
Engine Coolant Temperature (ECT) Sensor Rear of engine cylinder head, below intake manifold. See Figure.
Evaporator Temperature Sensor In HVAC module, near evaporator.
Front Wheel Speed Sensor - Right & Left On the inside of the front wheel. See Figure.
Fuel Pump/Sender Assembly In fuel tank. See Figure.
Fuel Tank Pressure Sensor In fuel tank. See Figure.
Heated Oxygen Sensor (HO2S) 1 At left side of engine, on exhaust manifold. See Figure.
Heated Oxygen Sensor (HO2S) 2 Downstream of catalytic converter. See Figure.
Input Speed Sensor (ISS) Connector On top of transmission. See Figure.
Intake Air Temperature (IAT) Sensor On air intake hose, between air filter & throttle body. See Figure.
Knock Sensor (KS) On right side of cylinder block. See Figure.
Manifold Absolute Pressure (MAP) Sensor Left rear of engine. See Figure.
Output Shaft Speed (OSS) Sensor Connector On output speed sensor. See Figure.
Output Shaft Speed (OSS) Sensor (Vehicle Speed Sensor (VSS)) On transmission. See Figure.
Rear Wheel Speed Sensor - Right & Left On the inside of the rear wheel. See Figure.
Rough Road Sensor Left rear of engine, on frame rail. See Figure.
Throttle Position (TP) Sensor On throttle body assembly. See Figure.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.