Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2005AVEO LS, 4D SEDAN, STANDARDREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESMECHANICAL - HYDRAULICDISC BRAKE SYSTEMREPAIR INSTRUCTIONSDISC BRAKE SPLASH SHIELD REPLACEMENT - FRONTINSTALLATION PROCEDURE
2005 Chevrolet Aveo LS, 4D Sedan, Standard
Installation Procedure
2005 Chevrolet Aveo LS, 4D Sedan, StandardSECTION Installation Procedure
- Install the splash shield.
- Secure the splash shield to the steering knuckle with the screws.
Tighten: Tighten the splash shield-to-steering knuckle screws to 4 N.m (35 lb in).
- Install the rotor. Refer to Brake Rotor Replacement .
NOTE:
Refer to Fastener Notice
in Cautions and Notices.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.