Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003VENTURE BASE, VAN CARGO EXTENDEDREPAIR AND DIAGNOSISELECTRICALGAUGESINSTRUMENT PANEL, GAGES, AND CONSOLEREPAIR INSTRUCTIONKNEE BOLSTER REPLACEMENTREMOVAL PROCEDURE
2003 Chevrolet Venture Base, Van Cargo Extended
Removal Procedure
2003 Chevrolet Venture Base, Van Cargo ExtendedSECTION Removal Procedure
- Remove the IP insulator. Refer to one of the following procedures:
- Remove the bolts/screws from the bottom of the knee bolster.
- Pull on the knee bolster in order to release the upper clips.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.