Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2003VENTURE BASE, VAN CARGO EXTENDEDREPAIR AND DIAGNOSISELECTRICALGAUGESINSTRUMENT PANEL, GAGES, AND CONSOLEREPAIR INSTRUCTIONCLOSEOUT/INSULATOR PANEL REPLACEMENT - RIGHTREMOVAL PROCEDURE

2003 Chevrolet Venture Base, Van Cargo Extended

Removal Procedure

2003 Chevrolet Venture Base, Van Cargo ExtendedSECTION Removal Procedure

Remove the push-in retainers from the IP insulator to instrument panel.
Remove the press-on retainers from the IP insulator to dash mat.

Fig 1: Removing Press-On Retainers From Instrument Panel Insulator To Dash Mat (Right)
Courtesy of GENERAL MOTORS CORP.
Unsnap the IP courtesy lamp from the IP insulator.

Fig 2: Removing Instrument Panel Courtesy Lamp (Right)
Courtesy of GENERAL MOTORS CORP.
Remove the IP insulator from the instrument panel.

Fig 3: Removing IP Insulator From Instrument Panel (Right)
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.