Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003VENTURE BASE, VAN CARGO EXTENDEDREPAIR AND DIAGNOSISELECTRICALGAUGESINSTRUMENT PANEL, GAGES, AND CONSOLEREPAIR INSTRUCTIONAMBIENT AIR TEMPERATURE GAGE SENSOR REPLACEMENT (OLDSMOBILE)INSTALLATION PROCEDURE
2003 Chevrolet Venture Base, Van Cargo Extended
Installation Procedure
2003 Chevrolet Venture Base, Van Cargo ExtendedSECTION Installation Procedure
- Install the outside ambient air temperature sensor to the vehicle.NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
- Install the outside ambient air temperature sensor to radiator (1) support bolt.
Tighten
Tighten the bolt to 2 N.m (18 lb in).
- Connect the electrical connector (2) to the outside ambient air temperature sensor.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.