Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003VENTURE BASE, VAN CARGO EXTENDEDREPAIR AND DIAGNOSISBODY & FRAMESEATSSEAT SYSTEMREPAIR INSTRUCTIONSSEAT SWITCH REPLACEMENT - POWERREMOVAL PROCEDURE
2003 Chevrolet Venture Base, Van Cargo Extended
Removal Procedure
2003 Chevrolet Venture Base, Van Cargo ExtendedSECTION Removal Procedure
CAUTION:
Refer to SIR CAUTION
in Cautions and Notices.
- Disconnect the front seat SIR module electrical connector.
- Disconnect the front seat pretensioner electrical connector.
- Remove the finish cover screws.
- Remove the finish cover from the seat adjuster.
- Remove the adjuster switch from the finish cover.
- Disconnect the adjuster switch electrical connector.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.