Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003VENTURE BASE, VAN CARGO EXTENDEDREPAIR AND DIAGNOSISBODY & FRAMESEATSSEAT SYSTEMREPAIR INSTRUCTIONSSEAT ADJUSTER TRACK COVER REPLACEMENT - FRONTINSTALLATION PROCEDURE
2003 Chevrolet Venture Base, Van Cargo Extended
Installation Procedure
2003 Chevrolet Venture Base, Van Cargo ExtendedSECTION Installation Procedure
- Snap the front seat adjuster switch to the finish cover, if equipped.
- Install the finish covers to the front seat frame.NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
- Install the finish cover screws.
Tighten
Tighten the screws to 2 N.m (18 lb in).
- Install the cup holder, if equipped. Refer to CUPHOLDER REPLACEMENT - FRONT SEAT .
- Install the map pocket net attachment, if equipped. Refer to MAP POCKET NET REPLACEMENT - FRONT SEAT .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.