Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2003VENTURE BASE, VAN CARGO EXTENDEDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTWIPER/WASHER SYSTEMSWIPER SYSTEM AND WASHER SYSTEMREPAIR INSTRUCTIONSWASHER PUMP REPLACEMENT - REARREMOVAL PROCEDURE

2003 Chevrolet Venture Base, Van Cargo Extended

Removal Procedure

2003 Chevrolet Venture Base, Van Cargo ExtendedSECTION Removal Procedure

Remove the washer solvent from the washer solvent container.
Disconnect the rear washer pump electrical connector.
Disconnect the rear washer pump hose.

Fig 1: Disconnecting Rear Washer Pump Hose
Courtesy of GENERAL MOTORS CORP.
Using a small flat-bladed tool, remove the rear washer pump from the washer solvent container.
Using a small flat-bladed tool, remove the seal from the washer solvent container.

Fig 2: Removing Seal From Washer Solvent Container
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.