Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2003VENTURE BASE, VAN CARGO EXTENDEDREPAIR AND DIAGNOSISACCESSORIES & EQUIPMENTCRUISE CONTROL SYSTEMSREPAIR INSTRUCTIONSCRUISE CONTROL CABLE REPLACEMENTINSTALLATION PROCEDURE

2003 Chevrolet Venture Base, Van Cargo Extended

Installation Procedure

2003 Chevrolet Venture Base, Van Cargo ExtendedSECTION Installation Procedure

Important: Ensure that the module strap is not twisted during the installation of cable.

Install the cable to the module band.
Install the cable to the module.

Fig 1: Installing Cable To Module Band
Courtesy of GENERAL MOTORS CORP.
Install the cable to the throttle lever and accelerator control cable bracket.

Fig 2: Installing Cable To Throttle Lever And Accelerator Control Cable Bracket
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.