SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003VENTURE BASE, VAN CARGO EXTENDEDREPAIR AND DIAGNOSIS (SINGLE PAGE)BRAKESANTI-LOCK BRAKESANTILOCK BRAKE SYSTEMREPAIR INSTRUCTIONSELECTRONIC BRAKE CONTROL MODULE (EBCM) REPLACEMENTINSTALLATION PROCEDURE
2003 Chevrolet Venture Base, Van Cargo Extended

Installation Procedure

2003 Chevrolet Venture Base, Van Cargo ExtendedSECTION Installation Procedure

Important:  Use only new wave springs and screws supplied with the new EBCM.

  1. Clean the BPMV surface with alcohol using a clean rag.
  2. Install the EBCM (1) to the BPMV.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the 6 screws that attaches the EBCM to BPMV.

    Tighten 

    • Tighten the top 4 mounting screws to 5 N.m (44 lb in). Tighten screws in an X pattern.
    • Tighten the bottom 2 mounting screws to 5 N.m (44 lb in).
    • Connect the pump motor connector to the bottom of the EBCM.
    Fig 1: Installing EBCM To BPMV
    G01483720Courtesy of GENERAL MOTORS CORP.
  4. Connect the EBCM harness connector and depress the locking tab (1) to secure.
  5. Install the air cleaner housing. Refer to AIR CLEANER ASSEMBLY  in Removal and Installation in Engine Performance.
  6. Turn the ignition switch to the RUN position, do not start engine.
  7. Perform the DIAGNOSTIC SYSTEM CHECK - ABS   . 
    Fig 2: Connecting EBCM Harness Connector And Depressing Locking Tab To Secure
    G01483721Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.