Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2003VENTURE BASE, VAN CARGO EXTENDEDREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEWINDOWSDOOR SYSTEM, MIRROR SYSTEM & WINDOW SYSTEMREPAIR INSTRUCTIONSMIRROR FACE REPLACEMENTREMOVAL PROCEDURE

2003 Chevrolet Venture Base, Van Cargo Extended

Removal Procedure

2003 Chevrolet Venture Base, Van Cargo ExtendedSECTION Removal Procedure

CAUTION: When working with any type of glass or sheet metal with exposed or rough edges, wear approved safety glasses and gloves in order to reduce the chance of personal injury.

Carefully push the outside rearview mirror face on the inner edge, near the front door window glass, to allow finger access.
Grasp the mirror face firmly and pull it from the mirror body.

Fig 1: Removing Mirror Face From Mirror Body
Courtesy of GENERAL MOTORS CORP.
Disconnect the heated mirror face electrical connector if equipped.
Disconnect the rearview mirror turn signal indicator electrical connector if equipped.

Fig 2: Disconnecting Rearview Mirror Turn Signal Indicator Electrical Connector
Courtesy of GENERAL MOTORS CORP.
Remove the 2 jackscrews from back of the mirror case
- Bend the 2 jackscrews over.
- Press down on the side of the jackscrew popping the screw from the mirror glass case.
- Save the jackscrews for reinstallation to the mirror motor.
Fig 3: Removing Jackscrews From Back Of Mirror Case
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.