SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003VENTURE BASE, VAN CARGO EXTENDEDREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEIGNITION SWITCH/STEERING LOCKSTEERING WHEEL & STEERING COLUMNREPAIR INSTRUCTIONSMULTIFUNCTION, TURN SIGNAL SWITCH REPLACEMENTINSTALLATION PROCEDURE
2003 Chevrolet Venture Base, Van Cargo Extended

Installation Procedure

2003 Chevrolet Venture Base, Van Cargo ExtendedSECTION Installation Procedure
  1. Install the turn signal and multifunction switch assembly (2) onto the steering column tilt head assembly.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

    Important:  Be sure that the electrical contact of the turn signal and multifunction switch assembly (2) rests on the turn signal cancel cam assembly.

  2. Screw the 2 pan head tapping screw (1) and (3) into the turn signal and multifunction assembly (2).

    Tighten 

    • Tighten the top pan head tapping screw (1) to 3 N.m (30 lb in).
    • Tighten the side pan head tapping screw (3) to 7 N.m (62 lb in).
      Fig 1: Identifying 2 Pan Head Tapping Screws & Turn Signal Multifunction Assembly
      G01483043Courtesy of GENERAL MOTORS CORP.
  3. Slide the 2 connectors (2) of the turn signal and multifunction switch assembly into the bulkhead connector (1).
    Fig 2: Identifying Turn Signal and Multifunction Switch Assembly Connectors
    G01483044Courtesy of GENERAL MOTORS CORP.
  4. Connect the turn signal and multifunction switch assembly connector to the SIR coil connector.

    Important:  The abrasion sleeve must be installed back onto the steering column wire harness assembly. The ignition lock cylinder case wires and connector must be hanging out of the middle of the abrasion sleeve.

  5. Install the wire harness assembly (1) into the wire harness strap (2)
  6. Install the upper and lower trim covers. Refer to STEERING COLUMN TRIM COVERS REPLACEMENT  
  7. Enable the SIR system. Refer to DISABLING & ACTIVATING AIR BAG SYSTEM  in Airbag.
    Fig 3: Installing Wire Harness Assembly
    G01483045Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.