Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003VENTURE BASE, VAN CARGO EXTENDEDREPAIR AND DIAGNOSIS (SINGLE PAGE)BODY & FRAMEEXTERIOR BODY PANELSBODY FRONT ENDREPAIR INSTRUCTIONSBRACE REPLACEMENT - FRONT FENDER UPPER DIAGONAL - RIGHTREMOVAL PROCEDURE
2003 Chevrolet Venture Base, Van Cargo Extended
Removal Procedure
2003 Chevrolet Venture Base, Van Cargo ExtendedSECTION Removal Procedure
- Open and Support the hood.
- Reposition the electrical center from the right front end sheet metal diagonal brace. Refer to UNDERHOOD ELECTRICAL CENTER OR JUNCTION BLOCK REPLACEMENT in Wiring Systems.
- Remove the windshield wiper system module cover. Refer toWIPER MODULE COVER REPLACEMENT in Wipers/Washer Systems.
- Remove the bolts from the rear hole in front and sheet metal diagonal brace at the wheelhouse.
- Remove the bolts from the front of the front end sheet metal diagonal brace at the upper tie bar.
- Remove the front end sheet metal diagonal brace from the engine compartment.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.