SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003VENTURE BASE, VAN CARGO EXTENDEDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTEXTERIOR LIGHTSLIGHTING SYSTEMSREPAIR INSTRUCTIONSREADING LAMP AND BULB REPLACE - OVERHEAD CONSOLEREMOVAL PROCEDURE
2003 Chevrolet Venture Base, Van Cargo Extended

Removal Procedure

2003 Chevrolet Venture Base, Van Cargo ExtendedSECTION Removal Procedure
  1. Insert a small, flat-bladed tool between the switch block/reading lamp housing and the overhead console.
  2. Press inward and down in order to release the switch block/reading lamp housing from the overhead console.
    Fig 1: Inserting Flat-Bladed Tool Between Switch Block/Reading Lamp Housing And Overhead Console
    G01534058Courtesy of GENERAL MOTORS CORP.
  3. Use a small, flat-bladed tool to push one of the tabs on the reading lamp socket to release the socket from the housing.
    Fig 2: Pressing Reading Lamp Socket Tab
    G01534059Courtesy of GENERAL MOTORS CORP.
  4. Remove the reading lamp socket from the housing.
    Fig 3: Removing Reading Lamp Socket From Housing
    G01534060Courtesy of GENERAL MOTORS CORP.
  5. Pull the bulb from the socket.
    Fig 4: Removing Bulb From Socket
    G01534061Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.