Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2003VENTURE BASE, VAN CARGO EXTENDEDREPAIR AND DIAGNOSIS (SINGLE PAGE)ACCESSORIES & EQUIPMENTCRUISE CONTROL SYSTEMSREPAIR INSTRUCTIONSCRUISE CONTROL MODULE REPLACEMENTINSTALLATION PROCEDURE

2003 Chevrolet Venture Base, Van Cargo Extended

Installation Procedure

2003 Chevrolet Venture Base, Van Cargo ExtendedSECTION Installation Procedure

Install the cruise control module to the mounting bracket.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
Install the mounting bracket bolt to the cruise control module.
Tighten

Tighten the bolt to 6 N.m (53 lb in).

Fig 1: Installing Cruise Control Module To Mounting Bracket
Courtesy of GENERAL MOTORS CORP.
Connect the electrical connector to the module.
Install the cruise control cable to the module. Refer to CRUISE CONTROL CABLE REPLACEMENT .
Adjust the cruise control cable. Refer to CRUISE CONTROL CABLE REPLACEMENT

Fig 2: Connecting Electrical Connector To Module
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.