Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT VARIANT/TRIMSECTION 2 (ENGINE CONTROL SYSTEM - SELF-DIAGNOSTICS - 5.3L)DIAGNOSTIC TESTSDTC P0230: FUEL PUMP CONTROL RELAY CIRCUITTEST DESCRIPTION
2003 Chevrolet TrailBlazer 4.2 S, 4WD
Test Description
2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Test Description
WARNING: This page is about a different variant/trim than selected.
The numbers below refer to the step numbers in the diagnostic procedure.
- 4
This step verifies that the PCM is providing voltage to the fuel pump relay. - 5
This step tests for an open in the ground circuit to the fuel pump relay. - 6
This step determines if voltage is constantly being applied to the control circuit of the fuel pump relay.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.