Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 97 (STARTING SYSTEM)TORQUE SPECIFICATIONS
2003 Chevrolet TrailBlazer 4.2 S, 4WD
Torque Specifications
2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Torque Specifications
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, 2002 Chevrolet RV Cutaway, and 2002 Chevrolet Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS
| Application (1) | Ft. Lbs. (N.m) | |||
|---|---|---|---|---|
| Battery Terminal Bolts | 13 (17) | |||
| Diesel (6.5L Engine) Only | ||||
| Battery Cable-To-Solenoid | 12 (16) | |||
| Starter Bracket Bolt-To-Engine | 13 (17) | |||
| Starter Mounting Bolts | 33 (45) | |||
| INCH Lbs. (N.m) | ||||
| Diesel (6.5L Engine) Only | ||||
| Ignition Switch Wires-To-Solenoid | 53 (6) | |||
| Starter Retaining Nut-To-Engine Bracket | 89 (10) | |||
| Gasoline Only | ||||
| Battery Cable-To-Solenoid | 89 (10) | |||
| Ignition Switch Wires-To-Solenoid | 18 (2) | |||
| Heat Shield Bolts | 27 (3) | |||
| Heat Shield Nuts | 53 (6) | |||
| Starter Field Lead Nut | 97 (11) | |||
|
||||
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.