SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 949 (STATIONARY WINDOW SYSTEM)REPAIR INSTRUCTIONSREARVIEW MIRROR REPLACEMENTINSTALLATION PROCEDURE
2003 Chevrolet TrailBlazer 4.2 S, 4WD

Installation Procedure

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Installation Procedure
WARNING: This page is about a different car, the 2004 GMC Sierra, 2004 GMC Cab & Chassis Sierra, 2004 Chevrolet Silverado, and 2004 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the center bottom of the mirror mount against the windshield at the top of the support button (1).
  2. Slide the base of the mirror onto the button.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Make sure the mirror is firmly seated on the windshield button by pushing down on the base of the mirror.

    Tighten:  Tighten the screw (3) to 1.8 N.m (16 lb in) in order to secure the mirror base to the button.

  4. Install the base trim cover.
    5. Fig 1: View Of Rearview Mirror Mounting Components
    GM787028Courtesy of GENERAL MOTORS CORP.
  5. Connect the electrical connector.
    6. Fig 2: Installing Rearview Mirror Electrical Connector
    GM787027Courtesy of GENERAL MOTORS CORP.
  6. Install the wire cover.
  7. Reposition the mirror assembly.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.