SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 938 (SEAT BELT SYSTEM)REPAIR INSTRUCTIONSCHILD RESTRAINT TETHER ANCHOR REPLACEMENT (PICKUP)INSTALLATION PROCEDURE
2003 Chevrolet TrailBlazer 4.2 S, 4WD

Installation Procedure

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  1. Install the tether anchor (1) to the seat frame with the mounting bolt.

    Tighten 

    Tighten the tether anchor bolt to 24 N.m (18 lb ft).

    Fig 1: Installing Tether Anchor (Pickup)
    G01478476Courtesy of GENERAL MOTORS CORP.
  2. Work the seat cover back to the original position.
  3. Engage the J-strip to the seat bottom frame.
    Fig 2: Installing J-Strips To Seat Bottom Frame (Pickup)
    G01478477Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.