SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 93 (AUTOMATIC TRANSMISSION SERVICING)REMOVAL & INSTALLATIONSHIFT CABLEINSTALLATION
2003 Chevrolet TrailBlazer 4.2 S, 4WD

Shift Cable: Installation

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Installation
WARNING: This page is about a different car, the 2002 Oldsmobile Aurora. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the shift control cable to the vehicle. See Figure . Slide the transaxle range selector cable (1) fully into the console until it snaps into place. Connect the transaxle range selector cable terminal to the shift lever pin. See Figure .
  2. Install the console trim plate. See appropriate SHIFT INTERLOCK SYSTEMS article in AUTOMATIC TRANSMISSIONS. Install the left console trim panel.
  3. Insert the transaxle range selector cable into the bracket. See Figure . Connect the transaxle range selector cable terminal to the transaxle manual shift lever pin.
  4. Insert the retainer to the shift cable mechanism. See Figure . Adjust the shift cable. See SHIFT CABLE  under ADJUSTMENTS.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.