SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 923 (ENTERTAINMENT SYSTEM)REPAIR INSTRUCTIONSCOAXIAL CABLE REPLACEMENTINSTALLATION PROCEDURE
2003 Chevrolet TrailBlazer 4.2 S, 4WD

Installation Procedure

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the radio antenna cable.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the radio antenna cable screws.

    Tighten 

    Tighten the radio antenna cable screws to 2.8 N.m (25 lb in).

  3. Install the radio antenna bezel.
  4. Install the radio antenna cable nut.
  5. Install the fender. Refer to FENDER REPLACEMENT -- FRONT in Body Front End.

    Tighten 

    Tighten the radio antenna cable nut to 6 N.m (53 lb in).

    Fig 1: Radio Antenna Cable Screws
    G01476506Courtesy of GENERAL MOTORS CORP.
  6. Install the radio antenna cable to the radio extension cable.
  7. Install the antenna mast. Refer to FIXED ANTENNA MAST REPLACEMENT .
    Fig 2: Installing Radio Antenna Cable To Radio Extension Cable
    G01476507Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.