SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 921 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSHIGH MOUNTED STOP LAMP REPLACEMENT (UTILITY - ENDGATE WINDOW)INSTALLATION PROCEDURE
2003 Chevrolet TrailBlazer 4.2 S, 4WD

Installation Procedure

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 GMC Sonoma, 2003 GMC Jimmy, 2003 Chevrolet S10 Pickup, and 2003 Chevrolet Blazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the electrical connector and push the connector through the hole in the body in order to install the electrical connector.
  2. Insert the rubber grommet into the hole in order to ensure that the hole is properly seated.
  3. Install the high mount stop lamp to the vehicle.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Install the screws that retain the high mount stop lamp to the endgate window.

    Tighten 

    Tighten the high mount stop lamp screws to 2.5 N.m (22 Ib. in).

    Fig 1: Installing High Mount Stop Lamp To Vehicle
    G01476334Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.