Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Multi Disc Loading
To operate the Multi Disc CD Changer in the multi disc mode, press and hold the LOAD button for two seconds. An audible beep will be heard and the LED to the right of the disc door begins to flash. The radio will also display the message "INSERT CD". When the LED stops flashing and turns green, load a disc. Once the disc is loaded the LED begins to flash again. The radio will also display the message "MULTI LOAD" to indicate the multi load mode has been initiated and the changer will begin accepting a disc for however many empty slots there may be.
When the LED stops flashing and turns green, load another disc. Repeat this procedure to continue loading discs. The CD changer holds up to six discs.
When the changer is full, six discs are loaded, and the LOAD button is pressed, three audible beeps are heard and the message "CHANGER FULL" is displayed.
To play one of the CD's, press one of the preset buttons.
NO RELATED
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.