SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 889 (LIGHTING SYSTEMS)REPAIR INSTRUCTIONSFOG LAMP REPLACEMENT - FRONT (AZTEK)REMOVAL PROCEDURE
2003 Chevrolet TrailBlazer 4.2 S, 4WD

Removal Procedure

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Removal Procedure
WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle.
  2. Disconnect the electrical connector from the fog lamp.
  3. Remove the nuts from the fog lamp.
    Fig 1: Front Fog Lamp Removal Procedure - Aztek (1 Of 3)
    G01515488Courtesy of GENERAL MOTORS CORP.
  4. Remove the fog lamp from the front bumper fascia.
    Fig 2: Front Fog Lamp Removal Procedure - Aztek (2 Of 3)
    G01515489Courtesy of GENERAL MOTORS CORP.
  5. Remove the fog lamp bulb from the fog lamp, turning counterclockwise, if required.
    Fig 3: Front Fog Lamp Removal Procedure - Aztek (3 Of 3)
    G01515490Courtesy of GENERAL MOTORS CORP.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready ToolsFree Quote CheckQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.