Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

SYS.OK|MANUAL.DB● LIVE

HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 878 (SEAT SYSTEM)REPAIR INSTRUCTIONSSEAT BACK REPLACEMENT - FRONTREMOVAL PROCEDURE

2003 Chevrolet TrailBlazer 4.2 S, 4WD

Removal Procedure

2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Removal Procedure

WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.

Remove the front bucket seat. Refer to SEAT REPLACEMENT - BUCKET .
Remove the outer trim panel from the front seat cushion. Refer to SEAT CUSHION OUTER TRIM PANEL REPLACEMENT - FRONT SEAT .
Remove the inner trim panel from the front seat cushion. Refer to SEAT CUSHION INNER TRIM PANEL REPLACEMENT - FRONT .
Remove the cable ends from the seat back recliner hinge.

Fig 1: Removing Cable Ends From Seat Back Recliner Hinge
Courtesy of GENERAL MOTORS CORP.
Disconnect the electrical connector harness for the side air bag from the front seat frame.

Fig 2: Disconnecting Electrical Connector Harness For Side Air Bag From Front Seat Frame
Courtesy of GENERAL MOTORS CORP.
Disconnect the electrical connector for the side air bag from the front seat frame.
Disconnect the heated seat electrical connector.

Fig 3: Disconnecting Electrical Connector For Side Air Bag From Front Seat Frame
Courtesy of GENERAL MOTORS CORP.
Remove the left front bolts from the seat back recliner hinge.

Fig 4: Removing Left Front Bolts From Seat Back Recliner Hinge
Courtesy of GENERAL MOTORS CORP.
Remove the right front bolts from the seat back recliner hinge.

Fig 5: Removing Right Front Bolts From Seat Back Recliner Hinge
Courtesy of GENERAL MOTORS CORP.
Remove the back from the seat cushion frame.
Set the back face down on the front seat cushion.
Remove the heated seat wiring harness and the side air bag wire harness. Remove the wiring harnesses through the front seat cushion and frame area.
Remove the seat back from the seat cushion.

Fig 6: Removing Seat Back From Seat Cushion
Courtesy of GENERAL MOTORS CORP.

RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

Shop Manual-Ready Tools Free Quote Check Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.