Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 878 (SEAT SYSTEM)REPAIR INSTRUCTIONSARMREST REPLACEMENT - FRONT SEATINSTALLATION PROCEDURE
2003 Chevrolet TrailBlazer 4.2 S, 4WD
Installation Procedure
2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Installation Procedure
WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
- Position the bolt into the mounting point of the armrest.
- Position the armrest to the front bucker seat.
- Tighten the armrest mounting bolt.
Tighten
Tighten the armrest mounting bolt to 4.5 N.m (40 lb in).
Important: Rotate the armrest bolt trim cap to a new position to allow the retainer on the cap to seat properly.
- install the armrest bolt trim cap pressing into place until fully seated.
- Inspect the armrest for proper movement.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.