Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHEVROLET2003TRAILBLAZER 4.2 S, 4WDREPAIR AND DIAGNOSISEXTERNAL PAGESDIFFERENT CARSECTION 860 (DOOR SYSTEM, MIRROR SYSTEM & WINDOW SYSTEM)REPAIR INSTRUCTIONSFROZEN LOCK CYLINDER REPAIRTOOLS REQUIRED
2003 Chevrolet TrailBlazer 4.2 S, 4WD
Tools Required
2003 Chevrolet TrailBlazer 4.2 S, 4WDSECTION Tools Required
WARNING: This page is about a different car, the 2003 Pontiac Aztek and 2003 Buick Rendezvous. However, it is still accessible from the selected car via links, so may be relevant.
J 25070 Heat Gun
Important: Do not damage the painted surfaces while using the heat gun.
- Apply heat to the cylinder area using J 25070
- Hold the shutter door open with a paper clip or similar item and force air into the cylinder using compressed air and a blow gun attachment.
- While holding the shutter door open inject a small amount of multi-purpose lubricant GM P/N 12346241 or equivalent.
- Work the key into the cylinder several times and wipe any excess lubricant residue from the key.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.